dot
 
  Products Current location:> Products > d-sub connector > D-SUB Composite power connetor > 8W8 power d-sub connector  

D-sub connector (power contact solder type) (8W8)
material

Rubber core: PBT + 30% GF, UL94V-0

Terminal: H62, the bottom layer of nickel, the surface contact area gold-plated, tin solder zone.

Shell: SPCC, the bottom layer of copper, the former shell surface nickel, after the shell surface tin.

Mechanical behavior

Insertion force: ≤3.3N / pin

Pull-out force: ≥ 0.3N / pin

Mechanical Life: 500 times

Applicable wire gauge: AWG 8/10/12

Electrical performance

Rated current: 20A, 30A, 40A
Rated voltage: 300V

Contact resistance: 15mΩ

Insulation resistance: 5000MΩ

Withstanding voltage: 1000Vr.m.s, 1mA, 60s

Packing:

Blister / small inner box / large outer box

Installation method:

Weld mode

Environmental requirements:

Meet the EU environmental requirements

Operating temperature:
-40 ° C to + 100 ° C

 

Features:
     Mainly applicable to communications and electronic data processing equipment and use
Similar to an electronic device or device. Frequency less than 3MHz, the product
In line with IEC60807 international standards, with similar products at home and abroad exchange.
     Such products are cable-welded connectors.
[·µ»ØÉÏÒ»Ò³]
dot

Copyright © 2005-2017 Shenzhen Uling Electronic Co.,LTD www.uling-conn.com 
Contact: Liao Xingping Phone:13713860097 Tel:0755-82360164 Tax:0755-82360164