D-sub connector (power contact solder type) (8W8) |
material
Rubber core: PBT + 30% GF, UL94V-0
Terminal: H62, the bottom layer of nickel, the surface contact area gold-plated, tin solder zone.
Shell: SPCC, the bottom layer of copper, the former shell surface nickel, after the shell surface tin.
Mechanical behavior
Insertion force: ≤3.3N / pin
Pull-out force: ≥ 0.3N / pin
Mechanical Life: 500 times
Applicable wire gauge: AWG 8/10/12
Electrical performance
Rated current: 20A, 30A, 40A Rated voltage: 300V
Contact resistance: 15mΩ
Insulation resistance: 5000MΩ
Withstanding voltage: 1000Vr.m.s, 1mA, 60s
Packing:
Blister / small inner box / large outer box
Installation method:
Weld mode
Environmental requirements:
Meet the EU environmental requirements
Operating temperature: -40 ° C to + 100 ° C
Features: Mainly applicable to communications and electronic data processing equipment and use Similar to an electronic device or device. Frequency less than 3MHz, the product In line with IEC60807 international standards, with similar products at home and abroad exchange. Such products are cable-welded connectors. |
|